This is our large corner profile aluminium channel for use with our LED flexible strip up to 20mm wide. The LED strip can be stuck into the base of the channel (with the self-adhesive tape supplied with the LEDs), frosted cover snapped into place and then the unit can be wired into a suitable power supply. The end caps have a small hole to allow the connection cable to exit but it is also possible to drill through the channel to wire in the cable from the rear. Please note, when mounting the LED flexible strip into the channel it is advised to check whether the LED is the correct length - for example a 100cm aluminium channel will not accommodate a 100cm LED strip with the end caps due to the cable and a 95cm or 90cm length would be advised. We have these adjusted lengths of LED available on the website, if the length required is not there, please email or call and we will happily supply this. If using our LED flexible strip, it is also possible to shorten the LED by cutting at the appropriate cut-point if already purchased.
Each length of aluminium comes complete with two end caps (as shown in the images), two mounting clips (although a good self-adhesive tape or adhesive could be used to mount the channel) and includes a frosted cover. The channel is available in 1.0m or 50cm lengths direct through the website or can be cut to length if you contact us direct via telephone or email. The aluminium can be mounted above or below lockers or anywhere where a discrete LED light is required. Two or more lengths of channel can be butted together to make a longer light, for example 2 * 1m lengths could be mounted with a 1.95m length of LED flexible strip stuck across the base of the two sections. The channel will accommodate most of our LED strips due to the size, allowing you to make a very bright worklight down to a low level ambient light.
This is our large corner profile aluminium and is 30mm wide, we also have a small corner profile available with 16mm width. There are also slim, tall or rounded profiles too, please take a look if this product is not quite suitable for your requirements.
We also have this aluminium channel made into switched light fittings on our website.
Please note that when ordered in lengths above 50cm, delivery will be made via a courier and will take 3-4 working days from date of order. Please contact us for details and additional cost if a speedier service is required.